Environment Paints  

Eco and Non Toxic Paint product specialists -

'Go Green Stay Clean'

Home

Products

Contact

FAQ

About

USES
(Interior & Exterior)
Walls and ceilings: - High traffic areas such as kitchens, hallways, stairways and living rooms, etc.
COLOURS
Available in White and Tint Bases which are compatible with all major tinting systems. Tinter, if added, should be shaken or stirred in thoroughly immediately after addition.
SURFACE PREPARATION
The surfaces to be painted must be firm, clean, dry and free from dust, loose material, chalky paint, dirt, mould and grease. Dust down and wipe with a clean cloth. Allow new cement render to cure for 30 days, remove loose sand by rubbing down with a timber block and sweep clean.
Previously Painted Surfaces
Before recoating previously painted surfaces, ensure that the surface is sound. Test at random for its ability to withstand extra coats. Simpy cut a small cross (x) through the paint with a razor blade, then place a piece of sticky tape firmly over the cut. Hold the end of the tape then rip the tape off. If the tape pulls the surface away, the surface is unsound. Test different areas before deciding whether or not the surface coating should be removed. Unsound surfaces should be stripped before repainting to achieve the best results. Fill cracks and holes with an appropriate filler.
APPLICATION
On prepared surfaces apply one (1) coat of Duralex Multi-Purpose Primer Undercoat followed by two (2) coats of Duralex EVERCLEAN, with a minimum drying time of two (2) hours between coats. Stir thoroughly using a lifting motion. To ensure best performance, do not use any additive not approved by Duralex. Pre-moisten brushes and rollers with water, shaking off excess. Do not allow paint to dry on brush or roller for a smoother, nib-free job. Slide roller and tray inside a plastic bag during meal breaks, etc.
WEATHER CONDITIONS
(Interior-Exterior) Surface temperature must be above 10°C  and not over 35°C  during application. Allow at least 2 hours drying before dew, fog or rain. Follow shade around the house in hot weather.
VENTILATION
Allow adequate cross ventilation when painting indoors during and after use to dissipate water vapour.
Note: Mechanical ventilation is required if painting in an area without open windows.
CLEAN UP
Do not pour left over paint down the drain.
See "Cleaning up after painting" for industry standard. Wash all equipment with clean water. Any dried spots may be removed using methylated spirits. 
STAIN REMOVAL
Maximum stain resistance is achieved after 7 days. For best results: remove source of stain immediately with the use of a non-abrasive household cleaner and cleaning cloth then rinse with clean water.
Wax based marks: Such as crayon, etc, are best removed wiping with mineral turps and a cleaning cloth.  
COVERAGE
A maximum of 16 square metres per Litre. This may fall below 10 square metres per Litre when painting corrugated, rough or absorbent surfaces.
SIZES
20, 15, 10, 4, 2, 1, 500mL and 250mL sample pots.
ENVIRONMENT
Low odour. Low V.O.C.
Environmentally friendly.
IMPORTANT
Keep out of reach of children.
To avoid spoilage of paint, keep container sealed when not in use.

Copyright 2008 environmentpaints.com.au